1. Check whether the fuse on the nail gun is blown, if not, please replace the fuse.
2. When installing, please tighten the screws with a wrench.
3. Please fix the nail gun on the reel according to the required length.
4. Please install the coil nails according to the specified length, and then tighten the screws after installation.
5. When using, please tighten the screws in the specified direction.
6. During use, if you find that the nail coiler does not work normally, please check whether the fuse is blown, whether the reel is stuck, whether the screws are loose, whether the power cord is damaged, etc.
7. Please do not use the nail coiler in places with combustibles.
8. When using the nail curler, please do not use too much force or blow air with your mouth.
9. After use, all tools must be returned to their original places, and the safety must be confirmed before leaving.
10. The main components of the nail gun are the handle, the bullet, the tail and the spring.
The effect of handle is to control bullet and bullet tail, and it forms 90 ° angle with spool, by the elastic force of spring, makes it move up and down. The length of the spring determines the length of the coil nail. If the spring is short, the longer the nail is, the easier it is to put in; if the spring is longer, the nail is shorter and easier to put in. When in use, adjust the spring length according to the actual situation. There are usually 3 methods: the first method is to adjust through the knob on the handle, the second is to adjust through the logo on the coil nail, and the third is to adjust through the switch on the coil nail head. Note: When adjusting, be sure to turn the handle counterclockwise to adjust.
Post time: Apr-14-2023