The nail making machine makes nails very fast, which brings a lot of convenience to people, but it may occasionally have some problems. The following are the problems that may occur with the nail cap.
1. No nail cap: This is a common fault, most of which are caused by the fact that the fixture cannot clamp the nail wire tightly. You only need to change the fixture. Another possibility is that the nail thread is reserved for punching the nail cap. Too short, just adjust the length of the reserved nail wire.
2. The nail cap is not round: This fault is usually also on the fixture. First, observe whether the countersink hole on the fixture is round. smooth. There is also a problem with the nail wire, either the nail wire reserved for punching the nail cap is too short, adjust the length of the reserved nail wire; or the nail wire is too hard to punch out the nail cap or the nail cap is unqualified , the nail wire needs to be annealed.
3. The thickness of the nail cap: It is also necessary to check the jig to see whether the height of the two jigs is the same, whether the jig can clamp the nail wire, and whether the counterbore of the jig has serious wear on one side In the end, it is necessary to observe whether the nail wire is too hard and the punched nail cap is unqualified.
4. The nail cap is skewed: first check whether the center of the two nail cutters is consistent with the center of the nail mold, whether the front and rear heights of the nail knife are neat, and check whether the sinking holes of the two nail molds are on the same plane, and finally check the mold shell Whether it is loose.
Post time: Mar-16-2023