(1) the structure and principle of the coil nailer are relatively simple, so its maintenance and maintenance is also relatively simple. As long as the coil nailer work, the nail roll into the nail can be. But because the nail is made of metal, so in the process of use will cause a certain degree of wear and tear on the metal. So in the use of the process should often check the wear and tear of the nail gun, and according to the situation in time to adjust.
(2) In order to make the coil nailer get better protection, new spring should be replaced regularly. When replacing the spring, you should pay attention to observe the working condition of the spring to ensure that the spring is in good working condition.
(3) When using the coil nailer, avoid using too much or too little force. Too much will damage the coil nailer, too little will cause low efficiency. Therefore, when using should pay attention to the operating methods and strength to avoid the use of improper and cause unnecessary losses.
(4) coil nailer maintenance and maintenance is relatively easy, but in the daily use of the process requires attention to the following points:
(5) when the coil nailer roll failure, should immediately stop using, and timely contact with professionals for maintenance. After the repair should ensure its normal operation.
3. Precautions
(1) operation should choose a firm place, so as not to affect the installation.
(2) Do not hit the nails behind or above the glass to avoid damaging the glass.
(3) Do not touch the nails with your hands during installation. Because fingers can scratch the nails. If someone accidentally touches the nail, stop working immediately and tell the people around you immediately.
(4) If the nail is very tight, it needs to be pulled apart first, and then installed.
(5) When the top of the screw is not completely fixed, you should press the screw firmly to make sure the bottom of the screw is not stuck. Excessive pressure should also be avoided to avoid damaging the screw.
Post time: May-12-2023