Operating requirements and routine maintenance of wire drawing machines

Drawing machine in the process of operation to start the speed of synchronization requirements, the need to maintain constant tension in the process of operation, the entire equipment requires synchronization of the time of stopping, there is no breakage of silk and tension relaxation phenomenon, the safety of the production requirements of the wire drawing machine wire breakage protection.

Wire drawing machine operation requirements

1. wire drawing machine in the processing operations should be carefully read before the drawings and technical information, so as to avoid causing bulk scrap or waste.

2. the wire drawing machine processing operations should be in accordance with the technical requirements to carefully determine the direction of drawing, drawing surface, the correct choice of drawing abrasive belts.

3. the whole process of processing operations should wear gloves, pay attention to the protection of the surface of the workpiece, to prevent scratches, bruises on the surface of the workpiece resulting in waste.

4. the wire drawing machine does not clean the workpiece directly drawn wire

5. the finished workpiece should be held lightly, and layered protection packaging, so as not to cause injury to the surface of the workpiece.

6. timely cleaning and recycling of waste boxes, fans work properly.Daily maintenance of wire drawing machine

(1), keep the outside of the equipment clean and sanitary, check the air supply line and quick connector is good.

(2), the upper and lower bearing seats and lifting screw lubrication (grease gun refueling).

(3), discharge the water in the air filter.

(4) Check the sanding belt and make balance adjustment.

System composition of wire drawing machine

1. The drawing motor of the drawing machine adopts S011Z3 type inverter, and the winding motor adopts S004G3 type special inverter for winding (equipped with external braking resistor to synchronize the running command and output frequency signal of INV1 of the host machine with the running command and frequency command of INV2 of the slave machine).

2. When stopping, full reels with large weights are braked in the opposite direction to prevent wire breakage due to inertia.

3. The JOG function realizes the pointing function during threading operation.