The working principle of stapler: It is a combination of gun body and clip, the gun body consists of gun body, cylinder, balance valve, switch assembly, firing pin assembly (gun tongue), buffer pad, gun nozzle, gun slot, etc. Using the difference between compressed air and atmospheric pressure, the firing pin (piston) is moved back and forth in the cylinder by triggering the switch, the clip device consists of gun head, gun cover, fixed clip, movable clip and other accessories The nail is fed into the slot in the cap by a compression or tension spring and is flushed out when the firing pin comes out of the muzzle.
How does the stapler fit the nail? First, press the switch in the gun notch position by hand so that the nail pin pressure strip pops out and the pressure strip is pulled out, then, remove the nail pin and place the pin face down into the nail pin slot, next, install the nail back pressure strip, after that, try the nail gun with nail pin to see if it works properly. So what do you need to know about using Staples? Here’s what you need to know.
1. Maintain a stable and appropriate air pressure. When using, pay attention to proper and stable air pressure, usually its air pressure according to the material of the nail and the size of the nail pin has a large and small, nails before use to check the air pressure, do not exceed 8KG/CM2, otherwise the nailed items are easy to burst open, set the air pressure, first from low air pressure to start, and then slowly increase, to achieve satisfactory results before doing.
2. Ensure the air supply. When using, you need to use dry compressed air without dust pollution, can not use combustible gas and oxygen, otherwise it will be dangerous, in addition, the gun is connected to the air tube, not in the nail can not pull the trigger, and each time after use, the air pressure tube and tools should be separated, to prevent the nail needle accidental firing caused by danger.
3. Correct use of lubricant. In order to ensure its performance, each time before use can be a few drops of lubricant, can extend the service life of shooting, do not use lubricant with additives or oil with scale, which is easy to damage the internal parts of the gun.
Post time: May-26-2023