1. The coil nail making machine installation should be measured level after fixing the ground screws and installed around the protective iron plate; connected to the power supply, and reliable grounding.
2. The new coil nail machine or replacement motor should check the motor steering before running, and then install the belt after correct: If the body is found to shake or jump in the machine operation, contact the maintenance immediately. Please close the door of the electrical cabinet when the equipment is running, and turn off the main power supply when carrying out electrical maintenance. Electrical components of the same type and specification can only be replaced. Be sure to ensure that no one touches the machine before the normal operation of the machine, that is, to confirm the safety of the machine on. In addition to regular lubrication, the equipment should be checked for normal operation before and after each shift, while cleaning the planing die, rollers, vibrating hopper, material track and table surface with alcohol wool or cloth head and carefully removing the fallen products.
3. Please do not carry out any maintenance or cleaning activities when the coil nail making machine is running. After cleaning the machine, you must check and remove any machine parts, tools and cloths or personal objects left around the moving parts to avoid danger. When operating all kinds of switches, please do not use inserts instead of fingers.
4. When operating the man-machine interface, it is strictly forbidden to use metal or sharp objects, and warm tips to cut flat your nails to avoid damage to the machine equipment. Machine operation in the absence of material, failure will stop.
5. should consider the principle of all-in-one machine wired control, in the change of material or maintenance, do sanitation before you must first press the stop switch to exclude the machine automatically start to bring harm.
6. The machine’s fault check has been working when the following happens: 8.
A. Although the start button is pressed, the machine. B. The machine suddenly stops when running, then the maintenance personnel should be contacted to find the faulty part and troubleshoot it.
7. In case of power failure and other emergencies, the power switch should be disconnected and then reported to the workshop management in time.
Two or three shifts of continuous operation of the equipment, the post staff should be handed over when the equipment operating conditions.
Fill in the maintenance records and equipment daily checklist in time, and do the handover work carefully.
Post time: Jun-30-2023